InovaPrint Wash - Safety Data Sheet

Modified on Tue, 7 Oct at 2:24 PM


1. PRODUCT AND COMPANY IDENTIFICATION


PRODUCT DESCRIPTION: InovaPrint Wash USE OR APPLICATION: 3D Resin Wash 


Company Information:USA
Company Name:  Harvest Dental Products, LLC
Street: City/ Zip: State/ Province:  905 Columbia St. Brea, 92821 California 
Country:USA
Telephone:  1+714-674-7400 
Emergency Telephone:  Infotrac: 1+800-535-5053 



2. HAZARDS IDENTIFICATION

Hazard Classification: 
Skin Irritation – Category 2
Eye Irritation - Category 2A
Skin Sensitizer - Category 1 
H315 Causes skin irritation
H319 Causes serious eye irritation.
H317 May cause an allergic skin reaction.
GHS US Labeling:
Hazard Pictograms (GHS US): 
Signal Word (GHS US):Warning 
Hazard Statements:Causes skin irritation.
Causes serious eye irritation.
May cause an allergic skin reaction.
Precautionary Statements (GHS US):Obtain special instructions before use.  
Do not handle until all safety precautions have been read and understood.
Wash hands thoroughly after handling.
Wear protective gloves/protective clothing/eye protection/face protection.
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
Dispose of contents/container in accordance with local/regional/national/international regulations. 



3. COMPOSITION / INFORMATION ON INGREDIENTS


Substances:
Not applicable 

Ingredients 


Name CAS No Percentage 
Proprietary Ingredient - Solvent Proprietary30-70%
Proprietary Aqueous Solution Proprietary 20-50%
Proprietary Carrier SolutionProprietary 10-30%

The specific identities are withheld as trade secrets of Harvest Dental Products LLC 


Further Information:
No further data


4. FIRST AID MEASURES
Eye:
Skin:
Inhalation:
Ingestion: 
Flush eyes with water for at least 15 minutes.
Wash with soap and water.
Remove to fresh air.
Consult physician.
5. FIRE FIGHTING MEASURE
Suitable Extinguishing media:  
Forbidden extinguishing Media:
Special firefighting measures:
Unusual fire and explosion hazard:
Special protection equipment: 
Foam, dry powder, carbon dioxide.
Full water jet
N/A
N/A
N/A
6. ACCIDENTAL RELEASE MEASURES
Personal precautions:  
Environmental Precautions:
Reclaiming Methods
:  
Ensure adequate ventilation.  
Avoid product spillage in sewage or drainage.
Wipe up with paper towels and dispose of in a suitable container.
7. HANDLING AND STORAGE
Handling precautions:
Precautions in case of fire:
Storage conditions:
Suggested container:
Environmental Precautions:
Other precautions: 
 
Avoid product spillage.  
N/A
Store in cool, dry place, away from any light sources.
Original mfr. container
Do not allow product to reach sewers and rivers.
Use according to directions  
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Exposure Limits: Chemical name:ml/m₃ ml/m₃CategoryOrigin 

N/AN/AN/AN/AN/A
Exposure Controls: N/A 



Ventilation: 
Local exhaust ventilation:
Special ventilation:
Mechanical ventilation:
Other Ventilation:
None
None
None
None 
Respiratory Protection:
Hands Protection:
Eyes Protection:
Skin Protection:
 

Other:
Environmental exposure control measures:
Prolonged exposure may cause drowsiness.
Protective gloves recommended.
Tightly sealed safety glasses.
Gloves; Prolonged exposure may be irritating to the skin.
None.
Do not empty into drains or the aquatic environment.
9. PHYSICAL AND CHEMICAL PROPERTIES
General information: 
Appearance:
Odor:

liquid, clear, colorless
weak odor 
Information related to health, safety, and environment: 
pH:
Boiling point:
Flash Point:
Flammable:
Lower Explosivity Limit: Upper Explosivity Limit: Oxidation:
Vapor Pressure: 
N/A
224-234C
>109C
No
0.7 Vol.-%
5.3 Vol.-%
N/A
<0.1 hPa bei 20C
Relative density:  
Specific gravity: Solubility:
Viscosity (dynamic): Viscosity (cinematic) Vapor density (air=1): Evaporation rate:
Melting point:  
0.95 g/cm3  
N/A
N/A
Not determined.
Not determined.
Not determined.
Not determined.
-67C
Other information:


Miscibility:  
Solubility in Lipids:
Not determined.
Not available 
Conductibility:  
Gases Group: 
N/A
N/A 
10. STABILITY AND REACTIVITY
Stability:  
Conditions to avoid:
Materials to avoid:
Hazardous decomposition products:
Further information: 
 
N/A
Heat
Oxidizing agent and aluminum.
Peroxide.
None
11. TOXICOLOGICAL INFORMATION
Acute oral toxicity:  
Acute inhalation toxicity:
Acute dermal toxicity:
Irritation and corrosively:
Sensitizing effects:
Effects after prolonged exposure:
Toxic-kinetic effects:
Effects on metabolism:
N/A
N/A
N/A
N/A
None known.
Could cause skin irritation.
N/A
N/A  
12. ECOLOGICAL INFORMATION
Toxicity:
Mobility:
Persistence and degradability:
Biocomumulative potential:
Results of PBT assessment:
Other adverse effects:
Not available.
Not available.
Not available.
Not available.
Not available.
Not available.  
13. DISPOSAL CONSIDERATIONS
Waste treatment methods
Observe all federal, state, and local regulations when disposing of this substance. 
14. TRANSPORT INFORMATION
DOT Land transport (ADR/ RID) (49 CFR 172.101):
Not a hazardous material with respect to these transportation regulations.
Air transportation (IATA)):
Not a hazardous material with respect to these transportation regulations.
Sea transportation (IMDG)
Not a hazardous material with respect to these transportation regulations.
15. REGULATORY INFORMATION
Risk Phrases:
36/37/38 Irritating to eyes, respiratory system, and skin.
Safety Phrases
2 Keep out of the reach of children.
9 Keep container in a well-ventilated place.
25 Avoid contact with eyes.
Further info:
The information is based on present level of our knowledge. It does not, however, give assurances of product properties and establishes no contract legal rights.
Sources of key data used to compile the Safety Data Sheet:
O.S.H.A.www.osha.gov  
European Chemicals Bureau (ECB)  www.ecb.jrc.it  
European Chemical Substances Information (ESIS) www.ecb.jrc.it/esis
A.C.G.I.H.  www.acgih.org
N.I.O.S.H.  www.cdc.gov/niosh
U.E.  www.europa.eu/index_it.htm
I.A.R.C. www.iarc.fr
N.T.P.www.ntp.niehs.nih.gov  
16. OTHER INFORMATION
HMIS RATING:

RATINGS:
0 = Minimal
1 = Slight
2 = Hazardous
3 = Serious
4 = Severe  


MANUFACTURER DISCLAIMER:  1 2 0 To the best of our knowledge, the information contained herein is accurate. However, Harvest Dental Products, LLC does not assume any liability for the accuracy or completeness of the information contained herein. Final determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards which exist.  



FRM-SDS-26 Rev 02 | Page 5 of 5




Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article